Ericsson LBI-39001 Manuale dell'Operatore Scaricare il pdf (Pagina 26)

3.2.2. GETC

Follow the normal installation procedures found in LBI-38894, GETC Maintenance Manual.

The configuration required for use with the EDACS equipment is shown below.

GETC CONFIGURATION

Control Channel/Working Channel, Downlink, and SCAT

Personality PROM

• Enable CONFIRMED CALL for all GETCs except SCAT. If the GETC programmer does not allow for this, it is

accomplished by a hex edit of the personality per feature programming instructions 349A9945P1.

• CTIS set to YES.

• Multisite System set to YES.

• Individual channels enabled for interconnect.

• Individual channels enabled for External CIU (digital interconnect) only.

• Maximum Interconnect Calls set to appropriate number for site.

• Recommend Special Call Hang Time of 30 seconds.

• Recommend Message Trunked Timer of 5 minutes.

• SCAT set to YES for SCAT GETC only!

3.2.3. Subsystem Verification at Sites

This section provides information on how to verify that the site subsystems are working correctly.

Test Results

Make a single-site individual call.

Called LID unconfirmed call

Hear channel access alert tone, then audio is